Quote:
Originally Posted by derbo
Quote:
Originally Posted by TigerTater
Hey man,
Just got my new tires and wheels mounted up, decided to not get new tpms sensors installed since my car has the older version anyway (11/08) build. I also don't have iDrive, so I don't get the nice features anyways. Am I able to code out the tpms like you did? I was looking on the other thread you cross linked..looks to be some confusion in regards to non CiC cars...
Thoughts? I also think my rdc module is located somewheres else different from your car
|
I believe the module is located behind the battery area in the inner trunk based on what I've looked at. In regards to non-iDrive, once you remove the VO and add the 265 VO, you should be able to just recode all your modules to defaults to reflect the new vehicle order. Note: this most likely will delete any previous coding you had before. You can go through the OBC Stalk to reset the tires once FTM is enabled.
##For which vehicle order to delete and add:
You can check your VIN for the Vehicle order (VO) that you need to remove. BMWVIN.com shows the VO code in the breakout.
##For example my car this is displayed:
S 2VBA Tire pressure display
2VB is the VO that i need to remove and add 265 for FTM for 2011. I'm unsure what the 09 ones are. |
So I do have the same s2vb VO as you to remove; I found the module and removed it .
Now gotta code new VO and settings.
Looking at what needs to be coded:
CIC: RPA_CIC
aktiv
CIC: RDC
nicht_aktiv
CIC: RDC_SAFETY
nicht_aktiv
KOMBI: RDC_ALIVE
nicht_aktiv
KOMBI: MMI_ENA_RPA_RDC
aktiv
KOMBI: RDC_VERBAUT
nicht_aktiv
KOMBI: DSC_MIT_RPA_CC
aktiv
KOMBI: RDC_DISP_SWITCH
nicht_aktiv
MK60_M3: RPA
aktiv
Since I don't have Cic do I just forgo that ecu? Or is there a substitute?