[roastbeef]

Parts are starting to trickle in, some are in the mail, and some are being built. This thread is going to be focused on the vision I have for this car, however silly, and sometimes that changes. I do my best at something, but I also change my mind, and make mistakes. The objective; to build a lightweight, beautiful, E92 M3 that is an absolute pleasure to drive.

Suspension;
-Moton 2-way coils with remote reservoirs and true rear coilovers. 550 pound springs up front, 400 pound springs in the back.
-Full SPL catalog.
-Fall Line rear LCA for true rear coil (SPL doesn’t make this part yet)
-Ground Control camber race camber plates
-MRF solid subframe bushings, delrin diff bushings *already on the car

DCT;
-Fluid and filter change
-Fall line DCT pan
-Do88 cooler

Lightweight bits;
-Carbon hood- talking with Luke Customs (to be used with aerocatch latches)
-Carbon trunk- talking with Luke Customs (to be used with aerocatch latches)
-Searching for carbon trunk floor
-Searching for carbon gt2 mirrors (RKP)
-Carbon gas tank service covers in the mail
-Finish removing all sound insulation and carpet
-Find more things to drill
-A/C delete
-More titanium
-Team Schirmer carbon door (oem replicas)
-Plastics4performance rear window and rear quarter windows
-Titanium tow hook/straps
-Voltphreaks VPH900 battery

Engine and drivetrain;
-Karbonius intake
-AFE xpipe (high flow cats, resonated)
-Vorsteiner type two titanium rear exhust
-Mfactory carbon driveshaft
-Drexler GT4 “lite” LSD by Florian, oem DCT 3.15 ratio
-Thinking of mild cams, but this is going to depend on budget
-Tune

Aero;
-Zebulon front splitter with 3D endplates
-Aeromotions S1 Dynamic wing. 72” width, 13” chord, extended uprights.
-Still exploring a flat floor and a real rear diffuser
-APR spats
-OEM GT4 canards



Brakes;
-Essex parts cp5060 (front) and cp5040 (rear) AP Racing brakes
-Speigler stainless brake lines
-Cobalt Friction Pads
-SRF fluid

Seats
-Sparco QRT-C seats (12.5lbs each)
-Brey Krause seat mounts for oem sliders (non-powered seats)
-Brey Krause harness bar
-Simpson Hybrid S HANS device
-Undecided on harnesses (I need some guidance and research here)

I'm going to expand on a couple of things a little later when I have time, particularly aero. I'll do some videos on a few parts here and there as they arrive. Its going to be amateur hour, don't expect great vids.
I'm completely open to debate and discussion.