Quote:
Originally Posted by gh0stE92M3
Look at the picture circled in yellow, it’s a plate that replaces the stock one and mounts in the same location which ties both sides together. You have to remove your rear trunk liner to be able to access this area. You’ll see the plate it replaces if you pop you liner off a little.
|
Does the upper leg have one or two bolt holes? Nevertheless, the thickness of the plate is going to bend out of plane if a normal forces is pulling the plate to the right in the picture. The mounting plate is not stiff enough out of plane to transfer the normal load-lateral bending moment to the mounting points. In a rollover, one side will be in compression and the other side in tension. That plate cannot support the loads generated during a rollover.