Well, my pass through duct plan didn't work out. The flat portion of the belly tray doesn't extent far enough back to pass it through there and have the duct not interfere with the tire when at full lock. So, I just cut a 3" hole towards the front, and then made it into a U shaped slot that inserts over the duct. Not as fun as what I was hoping for, but it works :P
Anyway...
Wheel turned all the way in:
Wheel turned all the way out:
All the way out, from next to the car:
Mounted up from the front:
Unless I run into unexpected issues, I think this is complete.