Quote:
Originally Posted by ///Mobbin
I just called and spoke to a Brey-Krause Engineer about my car and what parts to order, he recommended the following for an e92 m3 with driver's side Recaro Profi XL.
harness bar - r-1203 x 1 total
sub mount - r-9258 x 1 per side (not on website yet but recommended vs 59 part no.)
seat mount - r-9281 x 1 per side <-- even though Profi XL states 430mm it tapers at bottom so this is the recommended mount
harness lower clip ins - r-9289 x 1 (driver side part no)
harness lower clip-ins - r-9288 x 1 (passenger side part no)
|
I ended up ordering Cobra Imola Pro-Fit GT seats (wider version) and after emailing with Cobra and Brey Krause was told the wider seat mounts would be preferred for these seats. Just ordered the following:
harness bar - r-1203 x 1 total
sub mount - r-9258 x 2 (not on website yet but recd by BK vs 59 part no.)
seat mount - r-9280 x 2 (wider OE slider rail mounts)
driver side harness lower clip ins - r-9289 x 1
passenger side harness lower clip-ins - r-9288 x 1
Then I ordered the MTC brand electric slider switches (much cheaper than the OE parts) and the recommended pin contact and bushing contact parts from the installation instructions. Also ordered a pair of Enduro harnesses.
Can't wait to get all of this installed and try it out!