Quote:
Originally Posted by dpilat8588
I have never removed the plenum, but it doesn't sound too bad. I am more concerned with draining the coolant and and then adding it back in and bleeding it. Is that difficult or pretty straight forward?
|
syphon it out from the overflow tank. this job took me 3hrs and i have never removed the plenum prior. bleeding is easy, start the car and rev to like 2500rpms for 20 -30 secs. turn car off and loosen bleed screw, when the bubbles stop and fluid comes out tighten the screw back down. i hear this plastic screws break easy so careful. go for a quick drive to get it up to temp then purge air from screw again. you aren't draining the block so its not that complicated.
bought this kit:
https://www.ecstuning.com/b-genuine-...11537836155kt/
and the sensor:
https://www.ecstuning.com/b-genuine-...r/13621433076/
this pump to syphon:
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1