View Single Post
      05-07-2013, 03:12 PM   #9
tmntmn
///M
United_States
160
Rep
1,867
Posts

Drives: e92 M3/M-DCT
Join Date: Feb 2008
Location: Bay Area

iTrader: (6)

Quote:
Originally Posted by lsmkr01 View Post
I want to clean my engine bay this week. Any product recommendations or areas that should be covered so the pressure washer does not wet it?
I didn't use a pressure washer i just use free flowing water, first i covered up my EDC on both ends (only thing that might needed to be covered on our cars) and the spray APC then use a brush rinse with water and then wipe down with a micro fiber towel. Started up the car for a few mins to make sure everything is tried and use CG Black on Black spray.

Step 1 - engine bay has to be completely cold
step 2 - quick rinse down with water
step 3 -APC let it sit for a bit then use a rush
step 4 - rinse with water
step 5 - wipe down as much as you can
step 6 - start engine for 5mins+ to get rid of all the water build up you can't see
step 7 - pick your dressing of choice, i use some CG matte finish dressing and CG Black on Black spray

Before

After

__________________
THANKS TO:~<RPM>~ ~<SONICMS>~ ~<MODECARBON>~ ~<McKennaPerformance>~
MODS: MODECARBON V2 GTS FRONT LIP & REAR DIFFUSER, AA GREEN FILTER, RPI SCOOPS, PSW, Verstraβe Extended DCT Shifter, ZCP WHEELS (SEMI-GLOSS), OHLINS R&T, Megan Exhaust, AKRA XPIPE, BMW LED INTERIOR, BLACKOUT W/ORION V4 LED AE, OSRAM CBI

Last edited by tmntmn; 05-07-2013 at 04:30 PM..
Appreciate 0