Quote:
Originally Posted by Vic311
Error code ..fault code???..when you scan for codes through the OBDII port..
The OP had "a" code he just never posted what it was, he referred to have the rev limiter reduced which indicated possible limp home mode
|
You posted "Ok so seems m3an had it correct that its a DSC type fault as opposed to engine..but it will through that fault code"
And I was just saying that I was unsure if you were referring to an engine fault code or DSC fault code with your use of 'that'.
Semantics at this point. It's not that it
will throw a code if you spin out. It might and theoretically should not without extreme circumstances.
Codes scanned through the OBDII Port will be OBD II generic and will normally not show ANY DSC faults, unless you are using a specific tool designed for BMW bus systems and control units.