View Single Post
      04-25-2010, 02:40 PM   #12
Bob MG
Moderating
Bob MG's Avatar
United Arab Emirates
326
Rep
2,031
Posts

Drives: like a muppet
Join Date: Oct 2009
Location: Dubai

iTrader: (0)

You have to take a rubber mallet and really smack the heat shield area where the HFC sits to flatten it.

If you don't knock it enough the HFC sits like in your pics.

I had the Fabspeed X and once I did this it was 95% fine but most importantly, the clearance was good.

Go back to your fitment centre and do this

there is a fitment movie on Fabspeeds website which shows this