Ordered the "Elm327 wifi/obd2" interface and a few apps. I now have full access to EVERY engine parameter in realtime including but not limited to:
Vehicle speed
RPM
MAF
MAP
INTAKE AIR TEMP
OIL TEMP
TIMING ADV/RTRD
LAMBDA
A/F RATIO
O2 sensors voltage
Co2 emissions
Instant mpg
Avg mpg inc idle & w/o idle
Cat temp (est)
Vaccuum /boost
Hp & torque estimates based on correct weight & driver input, and gear ratios
Much more...
The hardware which I've seen for $75-200 on bimmian, was 15.99 + $5 on amazon, and arrived after 2 days...Sortware was free for some, others were $20 tops...
Because times be short, only used "dash command" so far which was plug and play. But d/l'd OBD2 link, OBD FUSION, and REV.
Once I enter the correct ip addresses and subnet masks w/ a static connection ill have those running as well. Each seems to have its own cool features...
Also updating software to have "connected apps" so I can monitor these parameters on my in dash TV...
Great way to gauge mods improvements etc
Pics later...