Idle Control Valve?
Hello guys.
Today I have Check Engine light and limp mode. After restarting of engine the Check Engine light and limp mode appears again right after the starting.
I read the error codes and I have the next:
DME:
2B0D - Idle actuator monitoring, bank 1
2B57 - DME: Air-mass sensor, plausibility
2714 - Intake-manifold pressure sensor
2796 - Throttle: adaptation values incorrect
DSC:
5E19 - CAN DME/DDE, engine torque not adjustable
Does it mean that I should change the ICV? I need to be sure because ICV is so expensive. Is there a way to repair my ICV? Can I rinse or blow it?
After when I deleted all error codes and started the engine - it worked fine. But I didn't drive my car after that today. Maybe it appears again.
Thank you for any help.
Last edited by RomanK; 02-05-2017 at 11:06 AM..
|