Quote:
Originally Posted by Lucrecio84
Quote:
Originally Posted by jcolley
Quote:
Originally Posted by Lucrecio84
Yea I'm about 30k deep on the engine build. Didn't stroke it because removing material from the cylinder walls isn't a good idea when adding boost to s65 block. We dropped compression to 10.5:1
|
Why would you need to bore the cylinders to stroke it? I'm assuming the alusil was prepped for new rings anyway with new pistons, no?
|
I'm not sure. How else can you stroke a motor without boring the cylinders? I didn't build it myself so not too familiar with the specifics.
|
One can stroke a motor with a different crank shaft. It would allow the pistons to travel farther. If I recall correctly one would get a 4.2 L motor with the S65 block.