Quote:
Originally Posted by derbo
Quote:
Originally Posted by LandoT
So I had my RDC fail and am having problems getting the FTM to work. I was able to get TPMS coded out without issue. I have everything coded properly from what I have seen using Protool. Deleted 2VB. Made sure the RDC components were all not active, and all the RPA options are enabled in Kombi, DSC, and CIC menus. FTM shows up in my CIC but reset is greyed out. After driving I get a 60AD code. I can clear the code but it comes back after driving more and the reset remains greyed out. I have no other codes that should have an impact. The only other code is for transmission fluid deterioration (which is getting done soon). Any suggestions?
|
Try adding $265 VO and coding defaults on KOMBI, DSC, CIC. Is the RDC module unplugged?
|
I did add $265 and coded them to default as well as tried removing $265 and coding each module manually. Both resulted in the greyed out reset button, FTM System Error in idrive, and code 60AD. For now I just coded them out so I don't get the dash error.