|
Great DIY, keeps on getting thumbs up after a few years.
Today I swapped my M Performance for a Meisterschaft GT2. I referred back to this DIY a couple times to make sure I was doing the right thing.
I did run into an issue, I broke one of the bolts for the clamps that connects the cats to the connecting pipe. I had to run to Lowes thankfully found a similar replacement that did the job. If this happens to you it is a M8 bolt all thread 10mm.
What I found to be difficult is lifting the new exhaust in place while trying to slide the pipes into the connecting pipes, all this while you make sure you dont hit your rear bumper. Trying to do that without a hydraulic jack is very difficult.
At the end the result justified any problems. I am very happy with the sound.
Thumbs up to this DIY.
|