Quote:
Originally Posted by tom @ eas
It does.
In this image, you see pins 3/11 will go to vehicle side, with pins 2/10 going towards the module connector side.
|
This is actually backwards, 3/11 go to the receiver and 2/10 go to the vehicle side.
Quote:
Originally Posted by Ninja Please
Attachment 1320301
I finally got around installing this this morning. I swear I am not usually this slow haha.
I just came back from a test drive and it's still displaying the TPMS error message. I made sure to select TPMS reset via iDrive before the "drive off." I drove a good 2-3 miles around the neighborhood varying from 5 to 25mph. I also did notice the green LED turning on the MS unit when I plugged in the harness.
After the test drive, I tested the module programming (since default is "on" I didn't do this after install) and is not working - when I lift both front window switches to POS2 for 5+ seconds, blinkers are not turning on at all.
Did I wire something wrong? As you can see from my picture:
* 3/11 is connected to wires from the vehicle
* 2/10 is connected to wires from the receiver harness
* Red from MS is connected to Red on vehicle
* Brown from MS is connected to Brown-ish on vehicle
|
Just switch the 3/11 and 2/10 like stated above.
I wired mine
Red Thick (Pin 9) - Red +12v Constant
Brown Thick (Pin 1) - Ground
Pin 3 - Green wire on module side
Pin 11 - Orange wire on module side
Pin 2 - Green wire on vehicle side
Pin 10 - Orange wire on vehicle side
Pin Configuration
1 2 3
9 10 11
Hope this helps