[Phil_M_Robinson]

Hi all

I have converted my E92 M3 from CiC to non-Nav specification.

In total, I removed the wiring loom that controls the Bluetooth, Navigation, SoS, and the wiring loom associated with that, the speaker system and the amplifier.

Everything is working fine still, with the exception of the front fender turn indicators. The front headlight and rear lights work fine, as do the indicators there.

I did not cut any wires, I removed the loom end to end - and cannot understand why the indicators are now not working.

Also, the indicators front and rear are not blinking excessively quickly, and they work on turn signal and hazards...

It would also appear that I have voltage on the pins when the turn signals are active, however I cannot say for certain what the voltage is as my meter doesn't react quickly enough to the momentary input - however the rough reading it could be showing is 12v (It's a series of blocks in intervals of 10 and I have 1 block)

Since the change also, my indicators do not flash on lock/unlock too

Any ideas?