Ok fellas - 36 hour update:
The thing is very, very solid...especially at the edges, where i was most concerned.
I will remove the remaining tape in the morning and clean it up a bit more.
One concern is that there appears to be about a one inch section on the front portion of the lip, where the betalink did not push out and it looks like theres a tiny gap there, ie not sealed, where as the rest of the perimeter is completely sealed.
I highly doubt the thing is going to go anywhere, but classic BMW OCD... Im pissed that theres a tiny section that isnt sealed.
Any thoughts? should i buy more betalink and try to seal that portion? Should I calm my OCD?
Any opinions would be very helpful here.
Thanks all!!
|