Quote:
Originally Posted by Robario12
Reviving this thread, as I am about to install an OEM Performance Spoiler in the next week or two.
I ordered the betalink.
One question is that I was really surprised when the spoiler arrived that it was sooo light. Additionally, the back edge of the spoiler (more towards the rear) has a little edge to add the adhesive and glue down, but the front edge (where there is a more severe angle) has a minimal edge/face to apple the adhesive.
Is this normal? Is there enough of an adhesion surface to hold this thing? I imagine there is since many people have installed successfully, but did anyone else have this concern?
Thanks all
|
Yes. Even if you see a small surface area in the front of the spoiler, just place beta link all around the spoiler but slightly. Not too much as then removing the mess is a mess. Hehehe.