[StripclubDJ]

Originally Posted by PsychCA

Thanks for your quick reply, bud.

I am kind of the same: spending my time, measuring, re measuring, over and over again to make sure everything is all good. LOL

So, I will base it on a full day work.

The hood was not too difficult to cut out ?

It's not to bad, after you tape down the stencils , drill the holes out in each corner , I used a 3in cut off wheel to start each cut line, then my snap in air saw and fine cut blade to cut along the stencil

Then a barrel sander to finish the edges
There's a decent write up on here from the blue e92 where you can get a idea and then go from there

I've done a lot of e46 vents , gtr vents , but my e92 was the first e92 I did