Big car work weekend. Did the following:
front rotors on my car (bigger process than it sounds and reused the hats... and they were quite baked on)
front pads, now with brake pad wear sensors!
rear pads
tranny fluid
diff fluid
valve cover gasket
valve adjustment
cabin air filter
cleaned the MAF sensor
engine air filter
GPS antenna replacement
trim rattle delete
track car front rotors
track car front pads
track car cool suit relocation
track car fire extinguisher relocation
90% of a brake bleed (ran out of brake fluid :P)
spark plugs
coil packs
sergei xenon fogs replacement
Suburban CB hardwired to switched power
redid suburban V1 hardwire so it can't run down the battery
Permanent suburban CB antenna mount and wire routing
Biggest win of the weekend: The new design brembo brake pads have pad wear sensors!
My rotors were at 4.3mm of wear... and you're supposed to replace them after 1mm of wear... so it was time. My slotted rotors had long since become blanks :roll: