Quote:
Originally Posted by arvinz
Quote:
Originally Posted by BLKLYZ
I couldn't figure out how to detach the steering wheel buttons from the steering wheel so I performed the swap while the button unit was still connected. Not too painful but had to do it at an angle. If you can get your control buttons completely removed from steering wheel then it would be a piece of cake. It took me about 40min from start to finish for the Mbutton. About 10min start to finish for the push start button.  Also the M button fit a little snug when seated which had me concerned with getting stuck when depressed however once reconnected to the retractable button, it performs like stock! |
Quick question on this..did you have to remove the center airbag module before you could pull the wheel trim off? I attempted it last night but I couldn't tell if the trim was tucked under the center airbag module and I didn't want to yank it and have it snap. |
I had the same problem when I started. No you do not need to remove the airbag module. The trim is sorta tucked behind it but There are 2 tabs located behind the left and right upper trim piece that causes resistance to just pull off. Check out the link below to guide you. It's what I used!