#Update 2018-11-16
I replaced my spark plugs last Friday. I have to say #4 and #8 were a pain in the butt! Luckily I ordered the Divisions Coil removal tool and GearWrench sparkplug socket to ease the process.
On another note, this past weekend I took out the M3 to a winery up north and did some damper adjustments. I've settled on the following settings:
Code:
Front
Rebound: 13
Compression: 5
Rear
Rebound: 11
Compression: 4
Overall, the low-speed oscillations seem to be a little over-damped but it is a slight compromise for the high-speed changes. At high speed, the overpass transitions where I normally would clench my butt to prepare for the bumps, went without any drama. There was a single oscillation and appeared to be critically damped.
I am very happy with the MCS. There is a little clunking with the Bimmerworld endlinks but I expected that and not worried about it.
The skies are crazy due to the fires.
