Ill make this quick and short. FYI DRIVER SIDE IS EASY.. PASSENGER IS A PITA... you will sweat..
EDIT: YOU HAVE TO BE REALLY CAREFUL ON THE COILS.. IF YOU DONT HAVE THE PULLER YOU CAN BREAK THE TOP OF THE COIL AND WILL MAKE IT MORE HARDER TO DO. ALSO WHEN PUTTING THE COILS BACK IN.. MAKE SURE YOU HEAR A POP.
Step 1.
YOU NEED
Spark Plugs NGK LKR8AP (4471)
10mm Socket with extension
Torx screw driver (T25) to remove air intake box.
Coil Pack Removal Tool - By TxStig (ITS A MUST) if you want this fast and easy.
Flat Head Screw Driver.
Spark Plug Socket x2 one with rubber and one without to hold the sparkplug when putting it in...
REMOVE THE INTAKE BOX
THEN REMOVE THE SPARK PLUG COVER (SLOWLY LIFT THE COVER ON BOTH ENDS
THEN THIS IS WHAT YOU SEE..
UNPLUG THE COIL FROM THE POWER SOURCE..
NOW START PULLING THE COILS START FROM THE BACK
NOW TAKE THE PLUGS OUT..
NOW DO THE SAME TO ALL THE OTHER PLUGS.
BEFORE AND AFTER DEALER PLUGS AND AMAZON PLUGS ARE EXACT SAME THING.. ALSO BEFORE PUTTING THE PLUGS IN MAKE SURE THAT SPARK PLUG GAPS ARE NOT TOUCHING THE MIDDLE PIN.. MAKE SURE THAT ALL PLUGS ARE GAP PROPERLY... USUALLY PLUGS ARE GAP PROPERLY FROM THE MANUFACTURE SO NO NEED TO GAP THEM JUST MAKE SURE.
NOW PUT IT BACK IN TORQUE IT PROPERLY AND PUT EVERYTHING BACK...
PUT THE COVER BACK
BEFORE YOU PUT EVERYTHING BACK WHILE YOUR AT IT I SUGGEST CLEANING THE ENGINE..
THEN PUT THE AIR FILTER BACK..
NOW THE PASSENGER..
REMOVE 2 10MM BOLT AND CAREFULLY MOVE IT TO THE SIDE... SEE BELOW..
(BE CAREFUL AND DO NOT BEND THE HOSE ALSO AT THE BOTTOM OF THE WATER RESERVOIR YOU NEED TO UNPLUG THE THE WIRE FROM THE RESERVOIR) I SUGGEST LOOKING AT THE HOSE WHEN MOVING IT OUT OF THE WAY
NOW REMOVE THE SPARK PLUG COVER AGAIN SLIGHTLY PULL THE COVER
NOW HERES WHAT YOU WILL SEE..
IF YOU HAVE A COIL PULLER IT WILL BE EASY..
NOW WHEN YOU TAKE YOUR COIL OUT MAKE SURE IT DOES THE WAY I HAVE IT... (FYI ITS A VERY TIGHT FIT)
NOW TAKE THE PLUGS OUT..
I HAVE THE COILS IN ORDER. ALL TAKEN OUT.
NOW START PUTTING THE NEW SPARK PLUG IN..
LISTEN NOW BELOW PHOTO SHOWS WHERE I TOOK OUT THE COIL.. NOW WHEN PUTTING THE PLUGS IN YOU HAVE TO PUT IT THE SAME WAY
NOW PUT EVERYTHING BACK TOGETHER...
Its seriously that easy.. the only hard part was the passenger side. The coil close the the wall is a PITA.. with a coil puller though it made it so much easier.
I dont know about you but to those who are sensitive will notice the difference. Engine runs smoother...
IF YOU HAVE ANY QUESTION JUST PM ME...