|
Okay, full Mickey Mouse mode here, but hey, it it works and doesn't damage anything, no harm. Pressing out the front two diff bushings.
1/2 plywood with 2 1/8" hole in it, two pieces of 1/8" steel, with 1/2" hole drilled through middle (one piece alone bends) and something to space the bar as the bushing comes out, which as you can tell was scrap from the garage). The rubber is bonded strong enough to the outer rim that the whole works comes out as one. When you're pulling the center center comes out about 1/2" in front of the bushing outer ring but it works. No complaints here!
|