Thank you everybody for the kind words!
Today I got some work done on the interior and put the bumper/headlights on so they could be compounded/polished. I also put the new lower grille on to see how it would fit the lower part of the bumper being slightly damaged and it fits perfectly into all tabs. I will get a Euro bumper eventually.
Started by taking the front seats out and cleaning the extras the PO had left;
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Grossness on the steering wheel;
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Notice the greasy looking film...
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
After. I used Leather masters 3 part kit for the leather, cockpit premium on the plastic pieces, my commercial heated carpet extractor, steam machine and shop vac.
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Apex wheels cleaned and ready for their coating, I'll be trying Kamikaze Stance.
Untitled by
jake ellegard, on Flickr
Hard to tell from the pictures but the seats look a lot better and don't have a sheen to them anymore.
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Untitled by
jake ellegard, on Flickr
Passenger side cleaned, middle and driver side not...
Untitled by
jake ellegard, on Flickr
Next, I need to finish the exterior polishing and apply the ceramic coating. All of the parts I bought should be here by Wednesday this week so Tuesday I'll be dropping the front subframe in preparation for rod bearings and putting everything else on to make her presentable.