Quote:
Originally Posted by Assimilator1
Regarding the bolts that need the 6" T30 socket, this is not a common tool, I'm reluctant to pay Snap on £25+VAT for a tool I'm only going to use for 1 job .
Seeing as the torque for those bolts are only 10Nm, I'm planning to use my 1/4" drive extensions and 8mm socket and 8mm T30 bit. (1/4" bits should be ok too).
But how big are the holes? Will a 1/4" drive 8mm socket fit down the holes?
SYT_Shadow Oh btw, re the op, it still has the error about 12 point sockets vs bi-hex, bi-hex sockets are 12 point sockets, they're the same thing .
Btw you mention qt in brackets in the torque settings, I thought qt was for quarts, a US fluid measurement, but you have it for the reinforcement plate bolts too, so what's qt?
|
I removed the bi-hex comments
QT means quantity. The torque value is in Nm at the end of each line
I'm not sure I understand what you're trying to do. If you mean use a 1/4 extension, the 1/4 extension fits in the holes fine, but the socket is too fat to get inside the hole.