Hello,
I tried doing the same to my E90 LCI 335i (N55 engine) 2011, but with partial success.
I did the following:
1. Removed physically the RDC module
2. VO setting $2VB - Removed
3. VO setting $265 - Added
4. I was able to FA Write - CAS ( I did not write LMA, LMA, because they are not in my list)
5. Programmed the ECU
CIC: RPA_CIC
aktiv
CIC: RDC
nicht_aktiv
CIC: RDC_SAFETY
nicht_aktiv
KOMBI: RDC_ALIVE
nicht_aktiv
KOMBI: MMI_ENA_RPA_RDC
aktiv
KOMBI: RDC_VERBAUT
nicht_aktiv
KOMBI: DSC_MIT_RPA_CC
aktiv
KOMBI: RDC_DISP_SWITCH
nicht_aktiv
--
Unfortunately I do not have M3DSC or MK60_M3. I have DSC and when I try to read it I get:
Error in CABD! Look at CARBI.ERR and ERROR.LOG!
COAPI-2020: ECU does not answer: IFH-0009:No response from controlunit DSC_87
--
So basically I did everything without one(and final) step, because I cannot allocate it.
My CIC module now shows FTM instead of TPMS, but it is saying
Status: FTM system error!.
The vehicle check is saying OK, and I do not get malfunction error. However I want to be have it working (the FTM).
Does anyone have any suggestions/clues what I did wrong or what can I do to finish the process?
Last edited by deadlyhate; 06-28-2020 at 10:04 AM..
Reason: Formatting
|