View Single Post
      02-04-2021, 03:43 PM   #15
jvictormp
Captain
jvictormp's Avatar
Brazil
880
Rep
784
Posts

Drives: 2008 M3 E92 6MT
Join Date: Dec 2018
Location: Brazil

iTrader: (0)

Done.

So, I needed to disconnect tri-angle flange at the trans, and the CSB, in order to fold the drive shaft, and get the clearance to remove it from the diff.

I don't know if every one had to do that and it was obvious, but for me it didn't look obvious. So if it's the case, OP should consider adding that information in the letter C of the procedure.
Attached Images
      
Appreciate 0