Quote:
Originally Posted by ItsGary
There's two variants, one has a off-centered hole and the other is in the center - compare both
|
Yep, I did. The one I took out of my engine was the center one, as was the part I ordered, INA-5320605100. The bolt just could not fit through. Seems like the inner diameter was just a bit smaller than the original.
I uploaded a comparison here:
The left pulley being the original, along with the bolt suggested (07119906591). The one on the right is INA-5320605100, which I could not thread the bolt through.
I ended up getting a Duralast idler pulley (part 231161) that was suggested in another thread, and the bolt threaded through fine. Been driving it for a week now with no problems so far.