|
12-06-2017, 09:24 PM
|
#70
|
Drives: E92 M3
Join Date: Nov 2010
Location: Orange County, CA
|
Quote:
Originally Posted by chamba002
Quote:
Originally Posted by BzsBimmer
I don’t have a picture but you cut back some of the wire jacket so the bare wire is exposed and then twist the two exposed pieces of wire together and crimp off using a wire crimp connector (butt splice) or electrical tape.
You won’t get electrocuted but disconnect the sensor first. Even if you don’t... you won’t get electrocuted.
|
Ok so, I'll disconnect the pad sensors but then cut into the pad sensor wire and the wire that connected to the car. Then with join those (pad sensors wire, and wire connected to car) together? Is that correct?? |
.
__________________
Instagram; @roastbeefmike
 |
|
|
|