Quote:
Originally Posted by icanturn
Hey guys, i'm running into this error right as I click "execute job".
My door shut on me while I was in the middle of writing it which turned the cars ignition off and when I went to do it over again this error popped up. the $265 change order is written to the module already.
From the research ive done I think I need to write a blank .MAN file but im not really sure how to do that or what/where it is. Is a .MAN file just a "Manipulation" profile with no changes?
Attachment 2671094
Attachment 2671095
|
IFH-0010 is a data transmission disturbed error. Try restarting NCSexpert again and making sure your KDCAN cable is set to whatever COM port you set in Edidabas with latency set to 1ms.
Good luck.
For recoding back to defaults just have a blank manipulation file (which is basically the work.trc named work.man) and run a SG_CODERIEN with that blank file.
edit: ooops, FSW_PSW.MAN, I should have drank my coffee before posting