01-08-2014, 02:17 PM
|
#10
|
Lieutenant Colonel
Drives: Sprint car
Join Date: May 2013
Location: California
|
274b - P2629
274B - P2629
274B - P2629 | | Information saved in | DME | Fault code | 274B - P2629 | Fault text | Oxygen sensor pump current calibration fault before cat. converter, bank 2 | Fault description | O2 Sensor Pumping Current Trim Circuit/Open (Bank 2 Sensor 1) | Condition for fault identification | Test condition: Oxygen sensor is available, oxygen sensor voltage > 4951 mV (K_LAVK_OBD_SA_DIAG_OL) | . | Terminal condition: Engine running - overrun condition | . | Voltage condition: none | Condition for fault memory entry | after a defined SA phase the lag period K_LAVK_OBD_SA_T (2.5 sec) must be completed | Action in service | 1. Check plug and wiring harness on pre-cat oxygen sensor LSVK B2 (especially trim circuit wire IA), | . | 2. If OK, replace oxygen sensor | Fault effect and breakdown warning | MIL lamp on after engine runs 2x /Small influence on drivability | Driver information | Warning light: MIL | Service instruction | None |
Last edited by regular guy; 01-21-2014 at 06:54 PM..
|
|
|