Just wanted to snap a few quick pics of the new Challenge GT3 front splitter that arrived just in the time for our Project M3 before it gets installed - bound for MFest V tomorrow.
Splitter is fully constructed from a carbon/kevlar combination for optimal strength, while remaining featherweight.
- Full carbon construction
- Carbon Kevlar used in low areas for increased strength and wear resistance
- Balsa wood splitter core for light weight rigid construction
- Provisions for brake ducting
- 3D aero design for optimal air movement under the car
- full sealed front undertray, mounts to oem panels and wheel liners.
- Extraction duct for oem oil cooler
Pictured is the GT3 Carbon Front Lip Splitter and Undertray Spoiler. This was prepared in a matte carbon finish to match the carbon interior trim on our M3:
And a quick shot of the weight for both pieces:
Time to get the M3 up on the lift and get these pieces installed.