View Single Post
      05-20-2020, 11:43 AM   #7
Kisenwether
Lieutenant
197
Rep
572
Posts

Drives: Limerock Grey M3 / Hellrot 1M
Join Date: Jan 2013
Location: Albuquerque NM

iTrader: (4)

I just joined the g1 club about a month ago. Been really enjoying the car even at the higher elevation here in NM. Install went super smooth besides two things I can into.

1. I didn't get the included hardware to mount the ground wire for the inter cooler pump as the instructions said but I found another place so this was nothing to worry about.

2. The second thing is and curious if you could check yours is the bolt right below the radiator hose that mounts the supercharger bracket to the motor (have to press the hose to see the bolt). I ended up bottoming out the bolt and it didn't press against the supercharger bracket. I had to take 5mm off the bolt to make it work properly. Not sure if the engine just had a slightly shorter bolt depth on my engine or the bracket was milled just a little to deep for that bolt.
Appreciate 0