I tried to register my new battery with Tool32.
I have the b***geek Pro INPA cable. I replaced with a new battery. I get the following error when trying to run the job "steuern_batterietausch_registrieren"
JOB_STATUS = ERROR_ECU_CONDITIONS_NOT_CORRECT_OR_REQUEST_SEQUEN CE_ERROR
The cable connection seems fine as I was always able to run INPA and read codes in the past. I have not started the engine since i installed the new battery.
To check my Tool32 connection I ran job "ident_ibs", which is reading the serial number of the ibs and that ran ok :
But then, i tried to run job : 'status_ibs' which from its description is reading the status of the IBS and i got the same error :
For all the above i selected MSS60.PRG in Tool32 and 'run job once'.
Although INPA is not required to register the battery i tried to view battery parameters in INPA by selecting MSS60 (M3) ECU and the STATUS (F5) menu,
but then i could not find any "IBS Status managment (F5)" menu to display battery parameters PM1 and PM2 like this user is doing on a E90 but he is selecting the MSD80 ECU.
Video link should start at the point where he is doing exactly that in INPA.
I double checked the battery cables. I don't think i missed anything.