Quote:
Originally Posted by SpartaEvolution
I doubt any solvents will bring it back to a perfect stainless finish alone, and it will be tough to solvent + wire brush them back to new without risking damage to the threads or mating surface. Bleed screws are relatively inexpensive items, so depending on how much $$ your time is worth, it's probably more efficient to just buy new ones. I would guess any M10x1.0 bleeder screw will work, but would recommend pulling one to measure thread length and pitch.
Again - I would assume something like this will work, but you should pull one and verify before purchase.
|
I rebuilt and repaint the kit also add the new bleeding screws. You were right. Those are M10x1.0 type . Thank the Brembo RT. They provided me all the parts I need!