[dpilat8588]

Originally Posted by nuespeedgti

syphon it out from the overflow tank. this job took me 3hrs and i have never removed the plenum prior. bleeding is easy, start the car and rev to like 2500rpms for 20 -30 secs. turn car off and loosen bleed screw, when the bubbles stop and fluid comes out tighten the screw back down. i hear this plastic screws break easy so careful. go for a quick drive to get it up to temp purge air from screw again. you aren't draining the block so its not that complicated.

bought this kit: https://www.ecstuning.com/b-genuine-...11537836155kt/

and the sensor: https://www.ecstuning.com/b-genuine-...r/13621433076/

this pump to syphon: https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

thanks for the response. Roughly how much fluid will I be draining? Will I know when to stop removing fluid? Where is the bleed screw located?