Quote:
Originally Posted by badfish
Here's how you do it.  You remove the circuit board from the crossover. Slice the plastic ribs on the door panel in the position below (you don't have to remove the ribs, I actually use them to kind of hold the crossover in place). Put a bunch of hot melt glue on the panel where the crossover will go. Then put more hot melt glue to hold it in place after you set it. If it is in the proper position with the depth minimized, the door panel will just snap right back in no problems. If it is not, then the coil will hit the door and not allow you to snap the panel back in properly. Position is key...
 |
Thanks... in the Sedan that circuit would be placed much better in the lower right hand corner of the door panel in that photo. The Sedan door panel doesn't have that lower right storage bulge shown in the photo.
