Quote:
Originally Posted by calicoupe
former 240 s14 Is that the BW distribution block? hard to tell from the photos. and do you have any photos of how you shaved the connector? One of the issues I ran into is literally the angle of the dummy switch connector based on where it tightens and the direction the connector faces. for instance it looks like your connector ended up perpendicular to the water pump housing whereas mine ends up parallel to it, making the connector fit even tighter. https://rallyroad.net/products/oilfe...1b19d973&_ss=r
|
Hello.
1. I can confirm my piece is the BW unit.
2. I do not have any more pics zoomed in for you
3. The OEM dummy switch goes vertical on the block, the aftermarket pressure sensor should go horizontal.
4. The shaving of the sensor was on one of the shorter sides removing it. The plug still has enough to clip in.
Hope this helps!
Rubin