[sperkins]

Guys,
I need some advice. I'm running V730's (275-35-18) that are shredding the outside shoulder. I finally split the rt front after a day at Thunderhill's 3mi layout.
The camber is 3.7, with a bit of toe out. You will see by the pics, the inner part of the tire is hardly worn.
The hot pressures are under 40psi. I try to start with 30psi.
Im running Ohlins Trackday Coilovers w Swift springs, 120 N/MM front, 180 N/MM rear.
Also running a Dinan front sway bar in the second hole (rear is the factory bar).
all joints are spherical, with a SPL adjustable front lower arm.

I really dont know where to go with this. Could there be enough body roll to cause the front end to loose camber on the outside tire?

- Should i move the waybar link to the stiffest?
- go to a stiffer spring up front?

-Steve