Quote:
Originally Posted by zstone
Went to look at it this weekend. Cam sensor was loose. So I swapped positions of both cam sensors on bank 2 and tightened them down. Checked the ground and all is good. I don’t see any bad wiring. Restarted the car and I am no longer getting the 2718 code for the cam sensor.
HOWEVER, I am still getting the other two codes
2761 - Vanos maximum stop inlet bank 2
271C - Vanos regulation inlet bank 2
Does anyone know what could be causing these codes? Would it be related to changing the Vanos covers?
Thank you in advance!
|
Did you do bolt on vanos covers or clip on? If you did bolt on, it could be timed incorrectly. I don't have a good answer if they are clip on.