|
I did my M3 with OEM bolts and a friend's M3 with VAC ARP bolts back in 2014-2015. Stock bolts were cheap back then, but I understand prices are up now. The savings is probably not worth the hassle, but you did not specify the savings.
You do not fully remove the bolt. You loosen it enough to repeat the torque procedure. I forget exactly, but it is something like 190 movements in total to use stock bolts versus about 1/4 of that to do any version of the ARPs. Pay attention. Have a checkoff sheet if you are not seriously attentive. This is not a job for someone with ADD. Basically, you are prestretching the bolts by doing the process twice before the final.
Reuse the subframe bolts. You can reuse the oil pan bolts, but make sue you use the exact size torx so you do not mess up the head. Put the bolts through the cardboard that comes with the new pan gasket so you know where each length bolt goes. You will need a long female torx -- like 4 to 6" (I forget) so buy one or come up with a skinny extension adapter that can reach into the deep cavity on a few of the bolts.
|