Quote:
Originally Posted by TRM04
I'm using the NT530 with BMW software - apparently it is the replacement to the NT510.
I do not have any experience with this product and there is very poor instructions on how to use it.
I am unable to complete any of the DCT resets from the Foxwell. In the sequence it asks to start engine, engage N, turn off engine. If you do that, it puts the car in park when you turn off the engine. The rest is unable to run.
I use the service lever to move it to N and followed the process but it still fails.
Can't find much answers online. I have seen videos of other software with similar steps but it doesn't ask to turn off engine after engaging N.
The test will not run with the engine on. So it fails again.
Any idea?
|
Old thread we'll see if you're still around mate: After realizing Protool doesn't do the actual clutch re learn I wonder of you ever manage to this with the NT530?
Thanks