Quote:
Originally Posted by amrazM
you need a dct shaft, what are you doing for the wiring? if I could interject here, i did this conversion but the other way around, if you have the ability purchase a DCT engine harness and replace it, repinning it would be alot of guessing. this will be the only difficult part.
|
I’ll get a shaft, might even go one piece but will try to get a used original one first.
I’m good at wiring and reading schematics so I’m not too worried, might even make a little adapter harnesse if possible still have to look into it.
What did you had to change in the engine harness when swapping in the 6 speed?