Quote:
Originally Posted by amg6975
If you don't want/need airbags that is by far the lowest hanging fruit. I'd bet nearly half the wire in the car is for the airbags and sensors.
In the KOMBI, code SFY_ALIVE_ZAEHLER and SFY_ID_MONITOR to nicht_aktiv then just unplug the ABG module and trace all the wires back to where they originate and remove them. Don't' forget to remove the airbag in the dash... it's heavy.
If you have race seats you can trace all the seat wire back to where it originates and remove it with no consequences. Same with the combox, amplifier/speakers, and FZD roof module.
My methodology was to just unplug stuff, code it out, make the car happy, then just pull all the wire out that goes to that particular connector then move on to the next thing.
|
That was my plan, start with radio stuff then airbag and safety components but was worried about coding the airbags as I wasn't sure what would happen when the impact sensors were removed. Still have my full headliner and curtain airbags.
Any idea of dashboard airbag weight? Pulling the dash sounds painful but would be an excuse to move to a single hump.
Thanks!!