Quote:
Originally Posted by chutak
Quote:
Originally Posted by Davisca455
|
Excellent post! Just ordered just the tensioner pulleys to replace while I'm in there replacing belts. Pretty substantial savings compared to purchasing each of the tensioner assemblies at $150+ each!
For those who've replaced the tensioner pulleys mentioned, what torque spec did you use for the center bolt? I figure I'd use the same as the idler (deflection) pulley, which is 15nm + 70 degrees turn. Does that sound right?
|
It's a 10mm coarse thread bolt, so 30ft lbs is what I torqued it to.
Factory install had red thread locker on it, so I cleaned the thread locking compound from threads of the bolt and the threads of the tapped hole, cleaned the bolt and tapped hole with alcohol, added Loctite 271 (red) and torqued to 30ft lbs.