[ProjektAutoScott]

I have a block with low compression and minor scoring in a cylinder due to an injector that was washing oil from the walls. No other catastrophic failure, or damage. Does anyone have recent experience with Millennium Technologies, e-megatronic, or any other machine shop capable of repairing Alusil bores?

Please post any Alusil machine shop recommendations you may have here, so far lots of companies in the country claim it will be “no problem”, but I am looking for the real deal, experienced shop who knows S65s. No interest in stroker or iron sleeved builds, no interest in used engines unless a forum member has a nice block.

My car is a higher milage e90, this is only about repairing this block to an acceptable condition. If I wanted absolute perfection, I’d buy a new short-block from BMW. Please know I understand the concerns from many members over attempting to repair these blocks.

Thanks in advance, I will likely be going with one of these shops, and I will post my experience publicly here for future reference.