Quote:
Originally Posted by anthony16r
Ok thank you. When putting it back together, should I just go as tight as I can then? I don't know if I'll be able to fit a torque wrench in there. I also may have to go get it balanced if it turns out the alignment of the splines is critical.
|
Normal practice is to mark it and put it back together in the same spot.
Yea, I don't believe there is a tq spec and there is not enough space to use a torque wrench anyways.
Check newtis, but I don't believe I saw one, also there is some directions you might want to read, such as lining up the ds with the diff input :
https://www.newtis.info/tisv2/a/en/e...shaft/1M2eLTGB