Quote:
Originally Posted by akkando
That crank case vent hose didn't seem to snap on quite like OEM. If I tug on it hard enough, I'm pretty sure it will come off without pinching the quick release. I yolo'd that shit because it seemed like it still sealed reasonably well and I didn't think it would come off unless yanked off by a hand. So far it hasn't come off. No CEL so I'm going to assume that hose is working correctly.
I can't quite get the bottom part of the hose to go perfectly over the notch there, but it hasn't budged since I put it on.
Another guy had the inner part of this pcv connector in the plenum fall off during shipping. He sent me a pic and I told him I wouldn't attempt install and to have it replaced.
|
I will say that yours has a better fit than mine. Hopefully you never have an issue with it.
Quote:
Originally Posted by statik
They all suffer this issue, my hose is only loosely attached. I’m surprised they shipped it like this.
|
It's crazy that there is so much variation. I compared pics from Eventuri's own website to ECS and there is a clear difference. The one from ECS looks like it would fit perfectly (inlet angled slightly towards center) while the one from Eventuri looks like it wouldn't work at all.