I finally got a cable that works and ran some tests using INPA and it definitely looks sick... Each cam fails on something:
Inlet #1
- Doesn't reach required max angle (137.9deg, min is 140deg)
- Adjustment time for opening seems to fail altogether?
- Ventilguete (valve?) seems to be maxed out
Exhaust #1
- Doesn't reach required max angle (122.6deg, min is 123deg)
- Minimum angle seems to fail altogether - doesn't register a value (did the test twice)
- Again, Ventilguete (valve?) seems to be maxed out
Inlet 2
- Doesn't reach required max angle (131.1deg, min is 140deg)
- Doesn't reach required min angle (73.2deg, min is 74deg)
- Again, Ventilguete (valve?) seems to be maxed out
Exhaust 2
- Finally, one that gets in to the green on max angle!
- Doesn't reach required min angle (80.7deg, min is 86deg)
- Again, Ventilguete (valve?) seems to be maxed out
The raw results are posted below... As soon as I get ahold of some replacement cam central bolts I will pull the top off and recheck the timing.
Thanks!
S.
